Results 1 to 2 of 2

Thread: S3 FFR 24v generator problem/questions

  1. #1

    Default S3 FFR 24v generator problem/questions

    Hi Everyone,

    I have a 1979 Series III 109 FFR I'm working on restoring to it's appearance when it was serving with 10 Para (V) TA circa 1982. My biggest problem at the moment is the generator. I'd been driving the vehicle for about 6 months without incident (though never over 40mph). When I finally did a highway run, the orange generator warning light began to come on around 50 mph and became steadily brighter the faster I went (speed topped out at 57 mph). Since then the light is on at all speeds/RPM ranges whether in gear and moving or out of gear and stationary. My first suspicion was there was too much play in the belts and they were slipping at speed. I have replaced them and set them to the correct tension with no change to the problem. I've concluded the problem is most probably in the generator (the cable appears undamaged) and was advised to check the brushes. Does anyone know:

    1. Is there a way to do this without removing the generator from the engine compartment?

    2. If not, how do I get the generator out?

    3. Does anyone in the States rebuild these things?

    Thanks in advance!

  2. #2
    Join Date
    Jul 2011


    Hopefully you've got a resolution to your problem since it's been a while, but I didn't see any replies so here goes.

    1. I don't know

    2. I took mine out of the Lightweight a few years ago, had a bearing fail so rebuilt wiht new instead of forking out for a replacement unit. If i recall, it's a simple process; remove the cable by unscrewing and disconnecting. then loosen and disconnect the bolt used to adjust the belt tension, finally there should be a bolt on the bottom used as a pivot for the tension, pull this and lift out the gen. It is heavy so beware

    3. I've not had the brushes done or anyone else work on the gen. but I did need the starter motor to be rebuilt at one point, I simply took it to an auto-electrician that specialized in 24v. commercial vehicles and RVs

    Hope my limited knowledge helps, and that the truck is running well


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
About us
Unparalleled product knowledge. Our mission is to support all original Land Rover models no longer supported by your local Land Rover franchise. We offer the entire range of Land Rover Genuine Parts direct from Land Rover UK, as well as publish North America's largest Land Rover publication, Rovers Magazine.
Join us