Results 1 to 2 of 2

Thread: crank position sensor

  1. #1
    Join Date
    Jan 2012
    Location
    South East Michigan
    Posts
    15

    Default crank position sensor

    I replaced the crank position sensor on my 04 Discovery and now it wont start only cranks over . symptoms before I replaced the sensor were misfires and stalling at idle after warm up . After car stalled , it wouldn't start back up . Only cranked over . Came back after a few hours and it started fine . After sensor change it just cranks like it did after stalling . Anyone have any experience with changing crank position sensors on the Discovery II ?

  2. #2
    Join Date
    Oct 2011
    Location
    Mountains of Western Pennsy.
    Posts
    569

    Default

    It's possible that you got a bad sensor. Other than that, check the plug to be sure it's good and plugged in fully (it can be a bear to get at). If more info is needed try "Disco Web", you'll find more tech over there.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Unparalleled product knowledge. Our mission is to support all original Land Rover models no longer supported by your local Land Rover franchise. We offer the entire range of Land Rover Genuine Parts direct from Land Rover UK, as well as publish North America's largest Land Rover publication, Rovers Magazine.
Join us