Results 1 to 2 of 2

Thread: Series IIa 109 / D1 Hybrid Build

  1. #1

    Default Series IIa 109 / D1 Hybrid Build

    Hey folks, I’m starting the process of moving a 71 Series IIa 109 body to 97 D1 chassis. The D1 has a solid V8 4.0. R380 & LT230. Does anyone here have experience with this build? I’m hoping for some advice to streamline the process. I'd like to keep the Series breakfast so any help with bulkhead placement, chassis lengthening, etc. would be greatly appreciated.
    Thanks, Bob

  2. #2
    Join Date
    Oct 2011
    Location
    Mountains of Western Pennsy.
    Posts
    592

    Default

    I haven't done this particular chassis swap. On my '76 Series III 109 I had to mount an electric fan on the outside of the radiator for engine clearance. There was no room for the stock engine fan in the engine bay. I have the old Range Rover drive train (3.5L V-8 and LT 95 trans/transfer case combination with Fairy overdrive), so I have V-belt accessory drive, which also saves a little space between the engine and the radiator. All else fit in pretty good with some custom engine and trans mounts. I had no issues with the bulkhead, be super careful if you have to lengthen the chassis, even a 1/4 of and inch off, from side to side, will cause problems. Good luck...

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Unparalleled product knowledge. Our mission is to support all original Land Rover models no longer supported by your local Land Rover franchise. We offer the entire range of Land Rover Genuine Parts direct from Land Rover UK, as well as publish North America's largest Land Rover publication, Rovers Magazine.
Join us