Zenith 36IVE?

[BobJones]

OK so I have a Solex on my SERII, It's in bad shape, so I was thinking of replacing it with an old Zenith that I have laying around. It is a 36 IVE, the solenoid is gone. So is there any problem using this on my serII?

• Is there any other difference in this carb

• can i just plug the hole where the solenoid was.

Thanks.

[siii8873]

I plugged the solenoid hole on a 361v and all was fine.

[BobJones]

Thanks.

[siiirhd88]

I think the Solex carb pushes up on the linkage to open the throttle, and the Zenith pulls down. You might have to find the later linkage, or have a really fun and different way to drive the truck....

IIRC, the Solex and most Rochester carbs push up, the Zenith and Webers pull down, and I had Holley carbs that went both ways.

Bob

[Terrys]

The Zenith, Rochester, Webber and Carter, all mount at right angles from the Solex. You'll need to get an adapter plate.
If the Zenith has been laying around a long time, take the cover off and check the body for warpage. Very common. Joint between cover and body won't seal on the gasket. Easy enough to fix. Get a sheet of 400 wet/dry paper, and when your wife goes to the store, put it on the granite counter top and rub the body joint till you have 100% bright surface.

[siii8873]

Float glass does the same thing as granite for lapping faces.