Middle Bulkhead

[PH4]

Does anyone know of the best/easiest/cheapest way to replace the middle bulkhead in 109 IIA. The PO had cut it out to fit a third gas tank. This was no big deal because I had a tropical top and it was a three door. I have since sold the tropical top and now am installing a pickup top but there is no middle bulkhead. Help! I guess I could buy some aluminum sheeting and rivet in place? Any advice or suggestions greatly appreciated.

[Terrys]

Knowing how they are put together, I can't even begin to think how you would go about replacing it. It may be easier to find another tub.

[thixon]

Sheet aluminum is expensive. Find another tub instead of screwing around trying to fab something up. If you find a decent tub, you can either paint and install, or if you're brave remove new bulkead and re-weld into existing tub (unless the're nothing to weld to. I'd have to see how it was removed.)

[leafsprung]

I have a 109 3 door middle bulkhead.

[SalemRover]

I have a 109 3 door middle bulkhead.

Good god Ike! What don't you have?

-Jason

[jp-]

Good god Ike! What don't you have?

-Jason


A Series IIA Lightweight.

Oh, wait...

my bad.

[PH4]

Does anyone have a 109 tub anywhere remotely close to South Carolina?

[thixon]

The guy on ebay listing the ball joints apparently has plenty of parts laying around (or at least that's what I've heard), maybe he has a center bulkhead. He's in Orlando. Here's the link to his ebay auction. You should be able to contact him through ebay. Sorry, I don't know his name. A buddy of mine has bought from him before though.

http://cgi.ebay.com/ebaymotors/New-Land-Rover-Series-Swivel-Ball_W0QQcmdZViewItemQQcategoryZ33728QQihZ001QQite mZ110210148774QQrdZ1QQsspagenameZWDVW