Tweet
Does anyone know of the best/easiest/cheapest way to replace the middle bulkhead in 109 IIA. The PO had cut it out to fit a third gas tank. This was no big deal because I had a tropical top and it was a three door. I have since sold the tropical top and now am installing a pickup top but there is no middle bulkhead. Help! I guess I could buy some aluminum sheeting and rivet in place? Any advice or suggestions greatly appreciated.
-
-
Knowing how they are put together, I can't even begin to think how you would go about replacing it. It may be easier to find another tub. -
Sheet aluminum is expensive. Find another tub instead of screwing around trying to fab something up. If you find a decent tub, you can either paint and install, or if you're brave remove new bulkead and re-weld into existing tub (unless the're nothing to weld to. I'd have to see how it was removed.)Travis
'66 IIa 88Comment
-
I have a 109 3 door middle bulkhead.Comment
-
Good god Ike! What don't you have?Originally posted by leafsprung
-JasonComment
-
Originally posted by SalemRover
A Series IIA Lightweight.
Oh, wait...
my bad.61 II 109" Pickup (Restomod, 350 small block, TR4050)
66 IIA 88" Station Wagon (sold)
66 IIA 109" Pickup (Restomod, 5MGE, R380)
67 IIA 109" NADA Wagon (sold)
88, 2.5TD 110 RHD non-hicap pickup
-I used to know everything there was to know about Land Rovers; then I joined the RN Bulletin Board.Comment
-
Does anyone have a 109 tub anywhere remotely close to South Carolina?Comment
-
The guy on ebay listing the ball joints apparently has plenty of parts laying around (or at least that's what I've heard), maybe he has a center bulkhead. He's in Orlando. Here's the link to his ebay auction. You should be able to contact him through ebay. Sorry, I don't know his name. A buddy of mine has bought from him before though.
Last edited by thixon; 01-04-2008, 09:41 AM.Travis
'66 IIa 88Comment
Comment