View Full Version : Another Galvanizing ?
ML-ENGR
01-05-2009, 03:09 PM
I have done a ton of googling and made many phone calls without any luck. Can anyone recommend a galvanizing shop say between SF, Reno and San Diego that they have personally had success with. Looking to do all trim, misc small parts, and possibly the bulkhead.
-thanks
greenmeanie
01-05-2009, 04:01 PM
I don't know if this is too far but I have just used these people in Phoenix. They had no problem at all with doing Rover parts. I'll comment on quality tomorrow when I pick my stuff up. Bulkhead, radiator panel and a box load of miscellaneous parts was a pretty reasonable price.
http://www.aztecgalvanizing.com/Locations.htm
Linus Tremaine
01-05-2009, 09:24 PM
But,
my friend keith who is restoring a 67 NADA dormobile used them.
They lost the interior door pulls (melted in the bottom of the tank presumably)
Good looking work otherwise from what I saw.
http://www.pacificgalv.com/
jac04
01-06-2009, 01:20 PM
They lost the interior door pulls (melted in the bottom of the tank presumably)
Same thing happened to mine!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.