crank shaft pully

[discocrazy]

ok friends, I am doing a head gasket overhau and everything is good, got the heads off, but was going to relplace timing chain and gears as well, so the problem is that I dont have the right tool to hold the crankshaft pully, it calls for a crankshaft pully lock wrench which i dont have. Could I use a chain wrench? What can I use besides the lock wrench?

[kh500]

ok friends, I am doing a head gasket overhau and everything is good, got the heads off, but was going to relplace timing chain and gears as well, so the problem is that I dont have the right tool to hold the crankshaft pully, it calls for a crankshaft pully lock wrench which i dont have. Could I use a chain wrench? What can I use besides the lock wrench?

I should have done timing chain and gears as well when I had head off but no time.


This photo is off from Honda forum showing a chain wrench.

http://img25.photobucket.com/albums/v75/NOFXcivic/Timing_Belt_13.jpg

http://www.clubcivic.com/board/showthread.php?t=17671

Good luck!

[kh500]

This would help to check other items while the head is out.

http://www.v8engines.com/engine-4.htm#pre-load