I suspected I broke a half shaft yesterday and I pulled them this morning to confirm. I've never had them out of the truck and was surprised to find a non-standard, waisted half shaft on the short side. Just a 10 spline so I was a bit surprised to see the extra engineering put into the waisted design. Anybody seen one of these before? Care to share some wisdom as to its origin for my edification?
Can anybody identify this shaft?
Collapse
X
-
Tags: None
-
Comment
-
Just tell her it's part of the new heavy duty paper towel dispenser.Jason
"Clubs are for Chumps" Club presidentComment
-
Comment
-
In my house I tell my wife to get back in the kitchen and make me a sandwich...
I'm a bad Mutha...
Birmabright Brotherhood
Take the vow, join the brotherhood!
Clint Rankin - 1972 SIII SWBComment
-
Will- appreciate the evidence that I'm not the only one who tempts fate over granite.
Maybe a new stickey is in order with rover's, or parts thereof being worked on in places likely to cause domestic distress......Ray
73 SIII 88 Daily Driver-patiently waiting for a good shop day
69 SIIA 109 NADA ~Someday...
61 SII 88 ~Shielding the earth from rainComment
-
I don't really have a good workshop. I will take a picture of my rear diff on the kitchen table as I remove the broken section of half shaft from it sometime soon!____________________________
1959 Series II 88"
"Grover"Comment
-
Seth
'67 IIa 109 Station Wagon (the daughter's toy)
2003 XC70 (for the dog)
2006 XC70 (for the wife/daughter/son)
2002 650 Dakar (for trip planning purposes)Comment
Comment