Weird vibration

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • J!m
    2nd Gear
    • Nov 2006
    • 295

    #16
    North Africa.
    Owner: James Leach Global Expedition Services.

    1995 110 Regular

    Comment

    • Tim Smith
      Overdrive
      • Nov 2006
      • 1504

      #17
      Originally posted by J!m
      North Africa.
      Out of curiosity, what did you do for parts when said disasters strike? Bring your own, buy locally, ship them in?

      Or should this be a new thread...

      Comment

      • TeriAnn
        Overdrive
        • Nov 2006
        • 1087

        #18
        If it were me, the first thing I would do is get the tyres rebalanced and check the front end freeplay & tie rod ends while the car is on the lift.

        Second thing I would suspect is U joints, third would be propshaft splines.

        Land Rover used off the shelf Spicer prop shaft ends, so any good propshaft shop will have a replacement part. The end Rover used cames in three spline lengths & Rover used the shortest one. You can upgrade your shafts if you have made any mods for increased articulation just by having a longer spline end installed.

        Originally posted by J!m

        PS the free-wheel hubs only starve the front upper steering pin and u-joints of oil. Make sure you engage the hubs regularly to move that oil around.

        I do not condone the use of free-wheel hubs, as they are a weak link prone to breakage and do not offer any substantial increase in fuel economy on a series truck.
        While I agree that freewheel hubs should be locked around town to keep the juices flowing, I have noticed increased power and fuel economy with them unlocked on the open highway. When you are out there climbing the West side of the Rockys the power difference is very noticable.

        I haven't been on the trail with anyone who had freewheel hub failure. Not to say it doesn't happen, just that I haven't seen it. I had to trouble shoot my Selectros on the trail in Moab once but the problem was me not putting a hub back together properly after replacing an inner oil seal.
        -

        Teriann Wakeman_________
        Flagstaff, AZ.




        1960 Land Rover Dormobile, owned since 1978

        My Land Rover web site

        Comment

        • Luke
          Low Range
          • Nov 2006
          • 32

          #19
          Re: FW hubs - Seems to me you really need to take a view on what you're using the vehicle for. If you're crossing Africa then I quite understand wanting to stick to the KISS principle. But if the vehicle spends it's life footling about somewhere like Connecticut, like mine does, with an AAA card tucked into the dash then I really don't see any issue at all. Like TeriAnn, I keep them locked most of the time but find there is a very noticable difference on long highway journeys and hills when you have a big old bus like a 109. Well worth having for my own set of circumstances.

          Cheers
          Luke

          Comment

          • Clive
            Low Range
            • Oct 2006
            • 79

            #20
            Just to thank you all for very useful advice - finally got it resolved - it was worn drive shaft splines! No longer a problem!

            Comment

            Working...