Hello, I did comb through a few posts. I'm sure someone has posted this before, I couldn't find them though. I thought I would just post and get a group of queries answered at the same time.
1.) Where is the brake light switch?
2.) There are 2 sets of connections on the servo/master cylinder. What is each connection for?
3.) Where do the rear lights ground? (I think I have a faulty ground)
4.) I don't have a specific question about the turn indicators yet, but I can get power to both lights by touching a hot wire to the rivets on the detached turn signal switch, I have not gotten them to flash (blink)...anything I might look out for when I go to connect them?
5.) What is the line coming out of the top of the front axle for? Where does it connect?
thank you in advance.
Tasi
1.) Where is the brake light switch?
2.) There are 2 sets of connections on the servo/master cylinder. What is each connection for?
3.) Where do the rear lights ground? (I think I have a faulty ground)
4.) I don't have a specific question about the turn indicators yet, but I can get power to both lights by touching a hot wire to the rivets on the detached turn signal switch, I have not gotten them to flash (blink)...anything I might look out for when I go to connect them?
5.) What is the line coming out of the top of the front axle for? Where does it connect?
thank you in advance.
Tasi
Comment