torque setting help

[clearcut]

I have replaced the following

Leaf Springs rear from RN
New Bushing for the front Leaf Spring from RN
New Motor Mounts from RN
New transfer case mount from RN
All new hardware


U-bolts set to 60
shackels 90


Need help on

Motor mounts
Transfer case mount
Bracket to Transfer case mount Pulled one nut apart at 60 pounds (old hardware)

thanks


josh

[SafeAirOne]

The mounts (engine and transmission) use lock washers and nyloc nuts, so those don't get torqued to a specific value. Just use German torque on these.

The brackets for the transfer case mounts use locking tabs under the bolts where they attach to the transfer case, so again, no torque values there either. You can use German torque here too or, if you're really obsessing about this particular triviality, you can just go with standard torque settings for the particular size and grade of fastener: