NADA motor and transmission mounts

[Armordave]

Question: are NADA (2.6cyl) motor mounts different than other Series/motors mounts? what is the correct P/N? In my research (on our host site) I can't find a specific one identified for the 2.6 cyl

Are the transmission mounts all the same (2.25 and 6 cyl models)? My research seems to show that these are all the same.

[clearcut]

they are the same, but I have been using

Engine Mounts S3 Diesel

josh

[Armordave]

is that the RNE400 part shown on Rovers North site? They are rectangular, mine are round?

[clearcut]

yes

[desullivan]

I also ordered the motor and trans mounts on RN. Asked the same question since the diameter of the replacement mounts is slightly smaller than the original motor mounts. RN recommended trying the 2.5L motor mounts if I was concerned as the diameter is a bit larger than the original however they will not fit the frame mounts on the left side.

[Armordave]

I bought the S3 diesel mounts (same for motor and trans)they are the square ones not the round ones; will install them this weekend and report on the results.