Need a 2.25L Diesel for series

[uralrover]

Looking for a series or early 90 2.25/2.5 L diesel to install in my own series before I head back to Iraq, for the wife to be able to use my Series III with. Durability and longivity are the key factors in the need for this. Any one have one or parting out one that I can aquire. Prefer a running engine but as I am a mechanic and located in NY I could probably get it fixed if minor enough within my tight time frame......Please let me know...315-523-5301 Aslo has anyone stuck a 2.5 NA into there series III? How much fun was that? Other then wirring what other headaches do I need to consider....
Thank You.

[leafsprung]

Durability and longivity are the key factors in the need for this

Thats probably the last reason to want a 2.25/2.5 diesel (or any rover diesel). SIII installation should be a snap. Change the RH engine mount. Wiring is not a headache at all . . .there is one wire for the glow plugs and one for the fuel solenoid. Fuel return lines etc. Rewiring your cold start lamp as a glow plug indicator is a nice touch. Really a simple swap.

[SalemRover]

I just put a 2.5 diesel into a LHD SIII. However it was not originally out of a defender but from a work van in the UK that used a Rover Engine. The differences between the two are the timing belt/cover assembly, injector pipes and injector location. The biggest complaint on the 15J is the timing cover is not waterproof, and it is a very fair and accurate complaint. Other than that everything else is a rover 2.5. There were several iterations of the rover 2.5 and are distinguished by the serial starting numbers. the 12J is the standard 2.5 diesel and the 15J is the Sherpa Variant. The 12J does require that you move the engine mount and the battery is relocated to under the drivers LH seat(just like a defender). The 15J does not need the motor mount moved and plops into the SIII motor mounts. Wiring is a breeze with the hardest bit being the relocation of the battery. Hope this helps.

-Jason

[junkyddog11]

Standard Rover 2.5 (12J?) does not require battery relocation.

[leafsprung]

Matts right, you can retain the battery location, but it does require a revised support bracket for the left rear leg of the battery tray as it rest on the engine mount. I made a new bracket and removeable tray to ease pulling the engine on the last one I did, but its in the same spot.

[c-delta]

Uralrover,
after all is said and done if you do decide to go with the Series 2.25D
I have one 4-sale. The head was cleaned-up (have receipts) and have
a brand-new Series 2.25D wiring harness to go with it.
Never reinstalled

$600.00 trans/transfer go with it
Toledo Ohio area

I too got another deployment rearing it's ugly head.

Bob

[Jim-ME]

I'm confused, what is wrong with a 2.25 or 2.5 Rover diesel as far as longevity is concerned?
Jim

[leafsprung]

they dont last very long

[Tim Smith]

they dont last very long

Neither will this thread.

[Grover73]

Diesel

C-Delta,

Is the engine that you have in bits? or is it all put together? any history on it? Thanks, Ryan

[junkyddog11]

they dont last very long

I'd agree with that as far as the 2.25 is concerned, but the 2.5na seems to go for quite some time without issue....although I'd be the first to admit to being no expert, those that I've taken down for inspection have been in great shape even with high miles. They are heavy smokers though.

[c-delta]

Grover,
the 2.25 still has the head off.
Got it off a guy in Indy that swapped it for a 2.25P. It had a blown
head gasket that I still have and you can see.
Have a compete gasket set to go with it. Now I can put the head back on
but you might look at the pistons,walls and top end.

Had one of these dinosaurs in a 109SW it was fun around town but on
the Hwy it turned out to be a hazard (45-50max).
I purchase this one for a back-up.

Like to get it out of here.
and this is one heavy engine as you might know--for shipping.

Bob

[yorker]

Ahhh that sounds like the one that was on eBay a while back.

[c-delta]

No-Ahhh about it Yorker
lets get the facts straight not this 2.25D.
don't know what your getting at on this one.

No disrespect intended.

Bob

[yorker]

Well there was one for sale in Indy on eBay- I don't remember if it sold or not. The fellow mentioned in a message to me that he thought it had a blown head gasket or something it had new or redone head, rebuilt injectors and pump- someone spent a whole lot of money on that engine. I'm not trying to "Get at" anything.