Removing Spotwelds

[Jim-ME]

I am getting ready to drill out spotwelds with a correct bits thanks to one of the members here. I would like to know if I should drill from the side that is the panel I'm removing, from the panel I'm keeping or doesn't it make any difference.
Thanks,
Jim

[Mercedesrover]

Drill just through the panel that you are removing and try not to drill through the second panel. Practice on some junk parts and you'll get the hang of it. You should feel a little "pop" when you get through the first panel and it seperates from the lower panel.

jim

[Jim-ME]

Thanks Jim. That's what my logic told me but I'm glad to know that my logic is supported by experience.
Jim