rear seat belts for a 109

**leafsprung** · 03-11-2008, 04:37 PM

I recently made a set for a 5 door. Pretty straightforward project.

**adkrover** · 03-11-2008, 05:13 PM

Leafsprung,

What hardware did you use? Where did you purchase it?

Thanks

**leafsprung** · 03-11-2008, 05:27 PM

Made it all except the bolts, which I bought at the local fastener supply.

**S11A** · 03-12-2008, 11:24 AM

You could probably use the same belts as the front, as long as the length was adequate for the mounting points you use.

As to mounting hardware, Racer Wholesale has backing plates, eye bolts, etc.:

http://www.racerwholesale.com/index.php?cPath=21_75&osCsid=83772dbda7ddb65ef6728f3b973

Use the backing plates on the underside of the vehicle to keep the bolts from tearing through the aluminum skin in the event of an accident, if you can't find a good spot on the structural elements such as the braces underneath the tub.

Our hosts might have the brackets to anchor at top. Not sure if the ones from the station wagons would work or could be adapted.

http://www.roversnorth.com/store/pc-223-276-page-47-land-rover-series-ii-iia-iii-defender-interior-seat-belts.aspx