Hi there, I am in need of some expert help.
I have a problem with the brakes in my Series lll. When I push the brakes it goes right to the floor. After 3 pumps I have a reasonable pedal although not great. There are no leaks and the pedal stays form until released. The rubber hoses show no signs of ballooning or over expansion.
I have re-sealed the rear cylinders, replaced the master cylinder and the front brakes are new by the way of a Rotor conversion kit. There is no air in the system as it has been bled several times both manually (pumping pedal) and by a power bleeder. My system has no servo.
Any suggestions? I am all out of ideas.
Thanks, Bob
I have a problem with the brakes in my Series lll. When I push the brakes it goes right to the floor. After 3 pumps I have a reasonable pedal although not great. There are no leaks and the pedal stays form until released. The rubber hoses show no signs of ballooning or over expansion.
I have re-sealed the rear cylinders, replaced the master cylinder and the front brakes are new by the way of a Rotor conversion kit. There is no air in the system as it has been bled several times both manually (pumping pedal) and by a power bleeder. My system has no servo.
Any suggestions? I am all out of ideas.
Thanks, Bob
Comment