Ok so my steering was sloppy so my bud and I adjusted the big nut and small nut.. it was great. I notice that I had a bad leak in the box so I then noticed one of my gaskets was totally gone ( one on the front where the worm gear presses on ). So I unbolted the cover and eyeballed the gasket... it was basically non existent... no worries quick trip to get some cork gasket and cut it out and put it in tomorrow and all is good.....
well...
we were doing some work freeing up the panels to access the gear box in the cab and we bumped the steering wheel (with the plate off)... big pop... ohh sh*t... worm gear pressed the race out and there goes the bearings.
So... my question is: Is there anyways to put the race and bearings back in with out taking the whole box out (its at a angle)? Please god I hope so. ohh and there now is a steering wheel with all the play in it you want now. any tricks? glue?
bugga!!!
http://www.roversnorth.com/store/c-56-steering-box.aspx <---#8 & 9 the one thats NOT closest to the steering wheel
thanks in advance
well...
we were doing some work freeing up the panels to access the gear box in the cab and we bumped the steering wheel (with the plate off)... big pop... ohh sh*t... worm gear pressed the race out and there goes the bearings.
So... my question is: Is there anyways to put the race and bearings back in with out taking the whole box out (its at a angle)? Please god I hope so. ohh and there now is a steering wheel with all the play in it you want now. any tricks? glue?
bugga!!!
http://www.roversnorth.com/store/c-56-steering-box.aspx <---#8 & 9 the one thats NOT closest to the steering wheel
thanks in advance
Comment