I bought a 109 6cyl thats been sitting in storage for a while, and Im getting it back on the road. It runs great until it warms up, then it sputters and dies. It did this a few times until it wouldnt crank at all and gave me no spark. I replaced the coil, and nothing. Then I replaced the condenser, and it started right up. Ran great until warm. Only to do it all over again. Now no spark. Seems like the condenser went out again.
recently replaced-
all the fuel line and the inline filter
plugs
coil & condenser
Ive checked out the distributor ground wire and its good
Main questions are-
-Why is this thing eating condensers?
-Any ideas on where to go next?
-Should the lower body (below the cap) of the distributor be too hot to leave your hand on?
Maybe I got a bad condenser..Im waiting on a few new ones in the mail so I'll try it out again this week..
PS
Ive really been enjoying the forum. Ive already spent hours reading old threads- this has been the best source of series info that Ive found yet, THANKS!
-Will
recently replaced-
all the fuel line and the inline filter
plugs
coil & condenser
Ive checked out the distributor ground wire and its good
Main questions are-
-Why is this thing eating condensers?
-Any ideas on where to go next?
-Should the lower body (below the cap) of the distributor be too hot to leave your hand on?
Maybe I got a bad condenser..Im waiting on a few new ones in the mail so I'll try it out again this week..
PS
Ive really been enjoying the forum. Ive already spent hours reading old threads- this has been the best source of series info that Ive found yet, THANKS!
-Will
Comment