Wanted to get a sense as to best practice for greasing ball joints. I was thinking of just prying the circular retaining springs off the boot and then depressing the joint with a c-clamp and then squeezing a bunch of grease in there. How tough is it to get the boots back on? I've got new joints and I'm assuming they're greased, but it looks to me like they're pretty stingy with the stuff. I can fully depress the boots without any evidence of grease movement.
I know some folks use a needle set-up to inject grease right through the boot. I'm not sure how you'd do that without a low viscosity grease and a syringe, but that's why I'm posting. What's the best route? Thanks.
I know some folks use a needle set-up to inject grease right through the boot. I'm not sure how you'd do that without a low viscosity grease and a syringe, but that's why I'm posting. What's the best route? Thanks.
Comment