tap size? steering relay retainer

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Broadstone
    2nd Gear
    • Jan 2009
    • 216
    #1

    tap size? steering relay retainer

    Hoping someone knew what tap is needed to clear the galvy for bolts holding the steering relay retainer. The one on the underside of the front X-member. Thanks
    1973 NADA 88
    Tags: None
    • martindktm
      2nd Gear
      • Jun 2008
      • 218
      #2
      Its 1/4"-28 fine thread.

        Comment

        • Broadstone
          2nd Gear
          • Jan 2009
          • 216
          #3
          Good I have that. Thank you very much!!
          1973 NADA 88

            Comment

            • martindktm
              2nd Gear
              • Jun 2008
              • 218
              #4
              The tap was hard to start when I did mine. I would recommend you to pass a drill bit through the hole before the tap.

                Comment

                Previous template Next
                Working...