Series III handbrake into a series IIa chassi

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Cristina
    Low Range
    • Jan 2007
    • 8
    #1

    Series III handbrake into a series IIa chassi

    Was anyone able to do this conversion? I just realized that the series IIa handbrake location is different from the series III. I would like to keep the series III handbrake but do not know how to get around this little problem. If anyone did this conversion can you please let me know how?
    Thanks
    Cristina
    Tags: None
    • leafsprung
      Overdrive
      • Nov 2006
      • 1008
      #2
      the only significant difference is the bellcrank assembly. The handle should bolt in with no issues. Where are you running into problems?

        Comment

        • Cristina
          Low Range
          • Jan 2007
          • 8
          #3
          The hand brake assembly is hitting the overdrive.

            Comment

            • leafsprung
              Overdrive
              • Nov 2006
              • 1008
              #4
              its close but should fit loosen bolts adjust and retighten. The cross bar is the same on the SIIA handbrake as well.

                Comment

                • Cristina
                  Low Range
                  • Jan 2007
                  • 8
                  #5
                  I am going to try. Thanks
                  Cristina

                    Comment

                    • jpasiczn
                      Low Range
                      • Jan 2010
                      • 11
                      #6
                      How about a IIa handbrake on a series III chassis? Any problems fitting this together? Im looking at a car that has this situation, and the current owner has not fit the handbrake yet. Any troubles with doing this?

                        Comment

                        Previous template Next
                        Working...