Lift points

[RoverForm]

So theoretically speaking, if I was going to get my steel wheels refinished and needed to lift and support the 88 on jack stands, what are the best points of lift and support while all four wheels are off?

There isn't enough axle space between the diff and spring on the right side to support under axle, so I was thinking of jack standing under the spring hangar plate...

[LaneRover]

I always do it on the spring hanger plate when doing wheels and/or brakes.

[RoverForm]

Do you use a floor jack or a hi-lift?

[RoverForm]

anyone ever leave an 88 on four 3 ton jacks stands for about a week?

[LaneRover]

only a week?

[RoverForm]

from today until about monday or tuesday.

getting the wheels re-done.

[NickDawson]

3 ton jack under the spring hanger plates should be fine. Sometimes I double up with a 2nd just behind it under the axel. The only problem I've had for long times is the jack base digging into the asphalt.

[RoverForm]

that's basically the set up i've got, one 3 ton jack stand under each of the four spring hangar plates. all the wheels are off. it's in the garage on concrete so sinking shouldn't be an issue.

but has anyone ever had a jack stand fail?

i just hope there isn't an earthquake in the next few days, otherwise i'm screwed.

[Lalo88DK]

I usually place my jack stands between the springhanger plate and the brakedrum underneath the axel, there is just enough space to place the 3.000 kg jack stands that I have, and it's very sturdy. Mine stood on the jack stands for about 3 month, when I was renovating.

[Jim-ME]

I suppose anything can fail but I've never had it happen. I wouldn't worry too much.
Jim

[73series88]

no worries mon.
aaron

[stonefox]

Jack stands are sooooo over rated

[stomper]

I had a set of cheap jack stands deform on me once, but they didn't fail. I picked them up to repair a trailer that was pretty light weight. Anyways, they were stamped thin steel. I have a much nicer set of cast iron ones I use for vehicles. If you have good jack stands, you will be fine. that is what they are made for.

[RoverForm]

thanks for the input. here's the set up. held overnight so it may be ok?

[jac04]

^^ I do the same thing with the block of wood when using my floor jack. My spring center bolts stick down a little, so I drilled a hole in the middle of them.

I have a set of jack stands, but rarely use them. Back in the late 80's my parents built a post & beam house in Maine. I saved quite a few pieces of the beams when they were cut to length, and I've been using them in place of jack stands ever since.