Part needed - wing stud plate?

[2manykids4a7]

I'm not really sure what to call this part but in the process of removing the grill and wing I broke it and need a new one. I couldn't find it in the RN catalogue (which may be user error!). Does anyone know where I could get one?

Part 13 in the following diagram.



Here is the one I broke.



Thanks, Steve..

[LaneRover]

The nice thing about those plates is that you only need 2 hands to undo the nut not 3 or 4.

That being said you could just cut the piece down to continue using the 2 bolts that haven't broken off and use a regular nut bolt and washers to replace the broken off bolt in whichever hole is most accessible.

[SafeAirOne]

Those anchor plates aren't rare...every rover parts seller sells 'em.

[Jim-ME]

I've got one I think. Let me check.
Jim

[ThorH]

I know I have just seen them on the Rovers Down South site.

[jumpmaster54]

Question

What is number 23 on that photo of the wing?

[jumpmaster54]

maybe 22

its the round thing that looks like it covers the mirror hole.

Sarge

[2manykids4a7]

LaneRover - Good idea. I do remember that I was able to get at one of the end bolts.

Mark - As I said, user error was and has been shown to be quite possible!

Jim-ME - Thanks, I appreciate the consideration. I have a small shopping list (see next post) and I am trying to find the most cost effective way to get it taken care of, maybe we can work something out.

ThorH - Thanks you are right, they were in with the radiator parts ($8)

Jumpmaster - I think you mean part 22, here is the list that goes with the diagram, it is item 36. Click the picture to go to the album so you can zoom in.



Steve..

[2manykids4a7]

Where to shop?

I may end up posting this elsewhere as well since it is a little off the original topic but hopefully it can be taken care of here. I broke this part while making room to do a head gasket job and here are the parts that right now I am planning on getting.

1. The radiator stud strip (if I choose to get one), apparently that is what it is called.

2. Genuine head gasket (does that mean copper?)

3. Set of other gaskets for thermostat, valve cover etc. (I'm wondering whether genuine is worth it here?)

I'd rather not have to pay 3 sets of shipping, but have been unable to find them all in the same place. Any ideas? Am I just really bad at part hunting on the internet?

Thanks, Steve..

[LaneRover]

I'd rather not have to pay 3 sets of shipping, but have been unable to find them all in the same place. Any ideas? Am I just really bad at part hunting on the internet?

Thanks, Steve..

I would call direct and ask, not everything is usually on the internet sites for most suppliers.