Ripped the Band Aid off! Build Thread and Advice Sought.

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • PH4
    3rd Gear
    • Jan 2007
    • 375

    #91
    The steering relay wins again today. Not for all we threw at it would it budge an inch. What a PITA! We did get the two front spring bushings out.

    Comment

    • albersj51
      5th Gear
      • May 2010
      • 687

      #92
      Sounds like a good time for a power steering conversion!

      Comment

      • PH4
        3rd Gear
        • Jan 2007
        • 375

        #93
        Any suggestions for what type black paint to use on the axles, diffs, prop shaft etc? I would prefer to brush on instead of spray. Should I wire wheel them first or just paint over what is already there? Best regards,

        Comment

        • albersj51
          5th Gear
          • May 2010
          • 687

          #94
          I would wire wheel them clean first, otherwise any rust will spread under the paint. A lot of people use Eastwood Chassis black for their axles and such, which looks awesome! However, I went with spray on rustoleum "professional".

          Comment

          • yorker
            Overdrive
            • Nov 2006
            • 1635

            #95
            Find SEM Products Rust-Shield and get Free Shipping on Orders Over $109 at Summit Racing! Get rust and corrosion under control with SEM Products Rust-Shield! Great for restorations and chassis work, these rust-preventive coatings are a great start to a perfect finish on your special project. Applied properly, SEM Rust-Shield isolates and forms a permanent, protective coating against rust. It resists runs, sags, and drips, while providing outstanding coverage and adhesion. For a tough, long-lasting finish, start with Rust-Shield from SEM Products.
            1965 SIIa 88",1975 Ex-MOD 109/Ambulance, 1989 RRC, blah, blah, blah...

            Land Rover UK Forums

            Comment

            Working...