Show us your Brush Guard

[NC_Mule]

1983 Camel Trophy used S3, 88"s.. Here's their version of a series brush guard. Protecting the lights, integrating jerry can holders and leaving the middle open..
~Steve

http://www.ticoracer.com/forum/attac...8&d=1328423514

Sweet, thats my favorite so far.

[toga Rover]

I wonder what one would look like that only came up in front of the wings on either side, just protecting the important stuff, not the 1-foot gap of nothingness before the radiator support/grille?

My personal opinion is that it would have all the functionality of a full-width brush guard, allow access to the engine bay if by some crazy chance a Series Rover owner ever needed access to that area, and look a whole lot better to boot. But then again, I've never seen a setup like this.

How about this one ??

[SafeAirOne]

How about this one ??

Yeah, like that! Except maybe have some 3/8" round stock going across each guard, like I've done here:




Credit: Basic 109 3D model done by Iceu on the Sketchup warehouse.

[I Leak Oil]

Nice Rover! The SI is pretty cool too!

[SalemRover]

Nice Rover! The SI is pretty cool too!

The only SI bits I see on that are the body panels

[toga Rover]

Another S3 with a flat-bar brush guard.
A bit more minimalist.

[disco2hse]

Here is an ex-army one for sale.

http://www.trademe.co.nz/a.aspx?id=629294614